Seeburg motor capacitor tested

Description

Original Factory Motor capacitor
_______________________________________________________________________________________
To CONTACT ME....
.LEFT CLICK
ON MY FEEDBACK SCORE.. .
THEN LEFT CLICK
ON THE RACE CAR
USE THE INFO FOUND THERE TO CONTACT ME.... I DO NOT ANSWER EBAY MESSAGE BOARD...!!
____________________________________________________________________________________
_____
______________________________________________________________________________
JUST SOLDER TO TOP LUGS.... NO PROBLEM....
i MARK THE CAN SO YOU KNOW WHAT COLOR WIRE.. GOES ... WHERE  !!!!!!!!!!!!!!!!!!!
Tested GOOD CAPACITY READING  within specs..!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
TOP is FLAT with no apparent heat buildup.....
NOTE..... what you get
may not
look like this one....
will be original factory  can type tho..
....
may have wires.. may not....
will be
good tested
tho...!!!
I just dont have time to change the
picture 26 times   !!
..
....
.NOTE..
... some
ORIGINAL CANS
are
1.4 and 1.0..... some are.....   .75 and 1.65.........
ALL ARE TESTED TO BE
WITHIN THEIR TOLERANCES..
shipping......
lower 48 only
REMEMBER it is an Electrolytic and old.....
No refunds no returns
....!!!!!!!!!!!!!!!!!!!!!!!!!
Check the worm gear shaft bushing above the motor !!!!!!!!!!!!  clean and lube it....
That can cause the cap to overheat...  !! if gear is binding....
You may not need my cheap cap...:)
Mike at OHIOSEEBURGREPAIR.......